The P0113 code is a general fault that occurs when the Intake Air Temperature sensor outputs a value higher than expected. This code is set by the engine computer when there is a problem in the IAT circuit 1. The ...
Ask4Auto Latest Articles
P0172 Fuel System Too Rich (Bank 1) Fault: What is it?
The P0172 fault code is set when the Engine Control Unit detects that there is too much (or not enough) fuel in the air-fuel mix. P0172 is a fault code that is triggered when the Engine Control Unit (ECU/ECM/PCM) detects ...
P0012 Intake Camshaft Position Timing is Over-Retarded on Bank 1 Fault: What is it?
The P0012 code is an error code for transmissions in general. This code is found in vehicles equipped with OBD-II and variable valve timing, such as Toyota, VW , Honda, Chevrolet, Hyundai, Audi, Acura etc. The Variable Valve Timing allows ...
P0174 System Too Lean (Bank 2) Fault: What is it?
The description of fault code P0174 is ‘System Too Lean Bank 2’. This code indicates that an engine lean condition has been detected by the Engine Control Module. Lean engines are caused by too much air and not enough fuel. ...
P015B Delayed Response from Oxygen Sensor Bank 1, Sensor 1 (Lean to Rich) Fault: What is it?
The oxygen sensors measure the amount of oxygen in exhaust gases, after the combustion process is complete. The Engine Control Module (PCM/ECM/ECU), which collects this information, is used to optimize the engine performance. The P015B code is set if the ...
P0341 Camshaft Position Sensor Circuit Range/Performance Fault: What is it?
The Engine Control Module (ECM/PCM/ECU), detects that the signal from the camshaft sensor is not correct. The fault code P0341 is triggered when there is a correlation between the signal from the camshaft sensor and that of the crankshaft sensor. ...
P0705 Transmission Range Sensor Circuit Malfunction Fault: What is it?
The fault code P0705 indicates the Engine Control Module or Transmission Control Module has received a transmission range sensor (TRS) error. The TRS sensor can also be referred to as the Transmission Position Sensor, Park Neutral Position switch, gear selector ...
P0327 Knock Sensor 1 Circuit Low Input (Bank 1) Fault: What is it?
Sensors are installed in your vehicle to collect and monitor various types of data. The ‘Knock Sensor,’ is one of these sensors. It is used to detect vibrations and knocking that can damage an engine. The knock sensor can cause ...
P0301 Cylinder #1 Misfire Detected Fault: What is it?
The fault code P0301 will be triggered by the vehicle computer when it detects multiple misfires on cylinder 1. When the air-fuel mix does not burn correctly in a cylinder, it causes misfires. The crankshaft, and therefore the engine, is ...
U0101 Lost Communication with Transmission Control Module (TCM) Fault: What is it?
Sensors and computers are used in modern vehicles to ensure the smooth operation of different systems. It is vital that the vehicle’s computer modules or computers communicate with each other to operate at its best. All vehicle functions may be ...